KidKraft Cedar Summit BEAR CAVE LODGE FSC Installation And Operating Instructions Manual page 80

Adventure Tower Assembly
Step 39: Upper Frame Assembly
A: Place 1 (6012) Short Post and 1 (6000) Upper Post side by side with the (6012) Short Post on the left side making
sure that the notched out end is at the bottom and facing the outside. Place (6023) Roof Side at the top of the posts
so that it's flush and attach using 2 (H2) ¼ x 2" Hex Bolts (with lock washer, flat washer and t-nuts).
B: Place (6029) Side Top so it lines up with the lower pre-drilled holes on the posts and attach using 2 (H2) ¼ x 2"
Hex Bolts (with lock washer, flat washer and t-nuts).
C: To make a second partial upper frame assembly place 1 (6012) Short Post and 1 (6000) Upper Post side by side
with the (6012) Short Post on the right side, notched side facing out and the (6000) Upper Post on the left side. Place
(6023) Roof Side at the top of the posts making sure it's flush and attach using 2 (H2) 1/4x 2" Hex Bolts (with lock
washer, flat washer and t-nuts).
D: Place (6030) Tunnel Side Top so it lines up with the lower pre-drilled holes on the posts and attach using 2 (H2) ¼
x 2" Hex Bolts (with lock washer, flat washer and t-nuts).
Set the upper assemblies aside, they will not be used until a later step.
Fig. 39.1
6000
Fig. 39.2
add 1/4" T-Nut to inside
of Long Post
Wood Parts
2 x Upper Post 1-1/4 x 3-1/4 x 58-7/8"
6000
2 x Short Post 1-1/4 x 3-1/4 x 36-3/4"
6012
2 x Roof Side 5/8 x 3-1/4 x 40-1/8"
6023
1 x Side Top 15/16 x 3-1/4 x 30-7/8"
6029
1 x Tunnel Side Top 15/16 x 3-1/4 x 30-7/8"
6030
X4
(Fig. 39.2)
6029
6012
loosely assmble
6000
add 1/4" T-Nut to inside
of Long Post
add 1/4" T-Nut to inside
of Long Post
(Fig. 39.1)
(Fig. 39.2)
H2
H2
LW1
FW1
TN1
LW1
FW1
6030
6012
Hardware
8 x 1/4 x 2" Hex Bolt (LW1, FW1, TN1)
H2
80
(Fig. 39.1)
H2
LW1
LW1
FW1
FW1
6023
TN1
H2
FW1
LW1
TN1
TN1
TN1
6023