KidKraft Cedar Summit BEAR CAVE LODGE FSC Installation And Operating Instructions Manual page 133

Step 76: Attach Elbow Assembly to Elbow Assembly
Part 1
Note: When installing Pan Bolts make sure to look at holes so bolts go
through the side with the round recess and the lock nuts go through
the side with the hexagonal recess. Keep all bolts loose until further
step.
A: Fit a second Elbow Assembly to the first Elbow Assembly by lining up the
arrows on each assembly. Notice the elbow orientation. (fig. 76.1)
B: Attach 1 TNR2 Slide Clamp Ring to the top of the joined Assemblies
using 3 (PB1) 1/4 x 3/4" Pan Bolts (with lock nut), making sure to match the
arrows up with the end of the clamp ring (where a seam will be) as shown in
fig. 76.2 and 76.3.
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
Do not install bolt
in Clamp Ring ends
until Step 76D
DO NOT USE
USE IMAGE
Fig. 76.3
Make sure
arrows are
aligned
Elbow
Assembly
PB1
3 x
PB1
LN1
Hardware
1/4 x 3/4" Pan Bolt
(LN1 lock nut)
133
Fig. 76.1
Notice elbow
orientation
Fig. 76.2
Top Slide Bolt Holes
Other Parts
1 x TNR2 Slide Clamp Ring
Elbow
Assembly