KidKraft Cedar Summit BEAR CAVE LODGE FSC Installation And Operating Instructions Manual page 136

Step 78: Attach Elbow Assemblies and TNR3 Tube
Support
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose until
further step.
A: Attach the two remaining Elbow Assemblies as instructed in Steps 75 and 76.
B: Place TNR Brace Assembly against (6002) Long Post so it sits under the slide. It is not attached yet. (fig.
78.1)
C: On the fourth Elbow Assembly attached remove the pan bolt and nut which is facing the fort (installed in Step
73). (fig. 78.1) The bolt will no longer be needed, but keep the lock nut.
D: Loosely attach TNR3 Tube Support (at the slightly bent end) to the Clamp Ring using 1 (PB6) 1/4 x 1" Pan
Bolt (with FW1 flat washer and the previously removed LN1 lock nut). (fig. 78.2)
E: Rotate TNR3 Tube Support and attach to (6002) Long Post using 1 (S6) #12 x 1" Pan Screw as shown in fig.
78.2.
F: Fully tighten screw and bolt.
Fig. 78.2
6002
Note: Flat
end down
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
TNR3 Tube
Support
LN1
FW1
PB6
S6
1 x #12 x 1" Pan Screw
S6
1 x 1/4 x 1" Pan Bolt
PB6
(FW1 flat washer & LN1 lock nut - previously removed)
16 x 1/4 x 3/4" Pan Bolt
PB1
(LN1 lock nut)
6002
Hardware
136
Fig. 78.1
Attach 2
remaining
Elbow
Assemblies
TNR Brace Assembly
Other Parts
1 x TNR3 Tube Support
4 x TNR2 Slide Clamp Ring