KidKraft Cedar Summit BEAR CAVE LODGE FSC Installation And Operating Instructions Manual page 129

Step 74: Attach Flange Assembly to Adventure Tower
Part 1
A: With a helper place the Flange Assembly flush to Slide Wall as shown in (Fig. 74.2), then attach Flange
Assembly to the (6022) SL Brace using 4 (S7) #12 x 2" Pan Screws (with #12 Screw Bezel) (Fig. 74.1) Make sure
the flat surfaces of the Flange Assembly are flush to the slide wall as shown in (Fig. 74.2)
B: Pre-drill 1/8" (3.2mm) pilot holes in the mounting locations on Lower SL Insert (approximate spots where circles
are on figure), making sure the pre-drilled holes are a minimum of 1" (25.4mm) deep. (Fig. 74.1)
C: Attach the Flange Assembly flush to Lower SL Insert using 4 (S6) #12 x 1" Pan Screws (with #12 Screw Bezel)
in the pre-drilled holes as shown in (Fig. 74.1) and to both left and right sides using 5 (S6) #12 x 1" Pan Screw per
side. (Fig. 74.1)
Fig. 74.1
Inside View
side
S6
x 5
the 4 holes need Lower SL Insert
to be pre-drilled
FW6
S6
S7
FW6
side
S6
x 5
6022
Hardware
14 x #12 x 1" Pan Screw
S6
4 x #12 x 2" Pan Screw
S7
8 x #12 Screw Bezel
FW6
129
Fig. 74.2
Outside View
Lower SL Insert
Flange Assembly
bottom flush
to SL Brace
Top flush to
the SL Brace
6022