Loading Base Image Software With Dvd - GE LOGIQ e R4 Series Basic Service Manual

GE
Direction 5370626-100, Revision 18

Loading Base Image Software with DVD

8-3-1
NOTE: While it is believed to be unnecessary, It would not hurt to disconnect the system from the
network and remove all transducers.
NOTE: Please ensure AC adapter is connected during system upgrade!
1.) Insert the disk labeled "System & Application Software" into the DVD ROM drive. Connect the
2.) Properly turn off the scanner by momentarily pressing the Power On/Off Switch. Select "Full
3.) If the system will not shutdown normally, hold down the Power On/Off Switch until the light
4.) Turn on the scanner. System will detect the DVD-RW automatically.
5.) Press any key to continue when below message display as shown in
DVD ROM drive to the system.
Maintenance Reboot" from the System Exit menu.
turns from green to amber.
Figure 8-2 Shutdown Dialog Box
Figure 8-3 Update message
Chapter 8 Replacement Procedures
LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Figure 8-3 on page 8-5
8-5
.