GE
Direction 5370626-100, Revision 18
4-3-10
Doppler Mode Checks
4-3-10-1
Preparations
1.) Connect one of the probes listed in
to the System probe connector.
2.) Turn ON the scanner (if it isn't turned on already).
Primary Menu
PW Mode
Gain
4-20
LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Figure 4-13 Controls available in Doppler Mode
Figure 4-14 Doppler Mode Screen Picture Example
Section 4-3 - General Procedure
3-6-6 "Available Probes" on page
B Pause/Enter
3-28, in Chapter 3 Installation
Secondary Menu
M/D Cursor