Table of Contents
Advertisement
GE
Direction 5370626-100, Revision 18
Chapter 10
Care & Maintenance
Section 10-1
Overview
10-1-1
Periodic Maintenance Inspections
It has been determined by engineering that your LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e system does
not have any high wear components that fail with use, therefore no Periodic Maintenance Inspections
are mandatory. Some Customers Quality Assurance Programs may require additional tasks and or
inspections at a different frequency than listed in this manual.
10-1-2
Purpose of Chapter 10
This chapter describes Care & Maintenance on the scanner and peripherals. These procedures are
intended to maintain the quality of the ultrasound systems performance. Read this chapter
completely and familiarize yourself with the procedures before performing a task.
Table 10-1
Section
10-1
10-2
10-3
10-4
10-5
10-6
10-7
Practice good ESD prevention. Wear an anti–static strap when handling electronic parts and
CAUTION
even when disconnecting/connecting cables.
BE SURE TO DISCONNECT THE SYSTEM POWER PLUG BEFORE YOU
DANGER
REMOVE ANY PARTS. BE CAUTIOUS WHENEVER POWER IS STILL ON AND
COVERS ARE REMOVED.
Do not pull out or insert circuit boards while power is ON.
CAUTION
Do not operate this unit unless all board covers and frame panels are securely in place. System
CAUTION
performance and cooling require this.
LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Contents in Chapter 10
Overview
Why do Maintenance
Maintenance Task Schedule
Tools Required
System Maintenance
Electrical Safety Tests
When There's Too Much Leakage Current...
Chapter 10 Care & Maintenance
Description
Page Number
10-1
10-2
10-2
10-4
10-5
10-11
10-18
10-1
Advertisement
Table of Contents
