Installing Base Software Load Image Cd - GE LOGIQ 5 PRO Service Manual

GE M S
EDICAL YSTEMS
D 2380207, R
IRECTION EVISION
Section 8-11
Installing Base Software Load Image
8-11-1

Installing Base Software Load Image CD

NOTE: While we do not believe it is necessary, It would not hurt to disconnect the system from the
network and remove all transducers.
1.) Power ON the scanner.
2.) Tap gently the DEL key until the following screen appears.Enter jupiter as a password if the system
request a password, then press the Enter key.
3.) The Setup Utility screen appears. Using arrow keys, Select Advanced Tab and select USB
Configuration and then press the Enter key. Verify that High-Speed USB is Enabled. If it is
disabled, using arrow keys, select High-Speed USB and press the Enter key and change it
4.) To exit USB Configuration, press ESC key
7
Figure 8-202 Enter Current Password
Figure 8-203 USB Configuration
Chapter 8 Replacement Procedures
LOGIQ™ 5 PRO S
ERVICE
M
ANUAL
8 - 177