GE LOGIQ e R4 Series Basic Service Manual page 173

GE
Direction 5370626-100, Revision 18
7-7-3 Insite II Configuration (For LOGIQ e R6.x.x/R7.x.x and LOGIQ e Vet R6.x.x/
R7.x.x)
(cont'd)
3.) Set Disruptive Mode Status as Enabled. Change to Utilities page. select Disruptive Mode in the left
column, Check whether the Disruptive Mode Status is Enabled, if not, click Yes to change the
Disruptive Mode Status as Enabled. See
There is another way to Set Disruptive Mode Status as Enabled. Click Insite Icon in system status bar,
choose Connect clinical Lifeline, the Insite Icon will change to RED, do not need to change if the Insite
icon is already RED. See
LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Figure 7-28 Device_Information page
Figure 7-29 on page 7-25
Figure 7-29 Set Disruptive Mode Status
Chapter 7 Diagnostics/Troubleshooting
Figure 7-28 on page 7-25
.
.
7-25