Brainlab CURVE DUAL System User's Manual page 50

Panels and System Ventilation
3rd-Party
Connections
Port
Display 1
and 2 In
Hospital
Network
Intraopera-
tive Data
USB
SDI In
Composite
In
Camera
Serial
50
Example Handling
Direct input of HDMI video signals without HDPC en-
coding to display external sources on the touchscreen
(no software interaction).
NOTE: Use high quality HDMI cable to connect a HDMI
source (max. 5 m).
Galvanic isolated ethernet port for connecting to hospi-
tal network or intraoperative data sources (min. Cat 5e
RJ45 network cable for max. 1 GB network).
There is a latch at the bottom which locks when plugged
into the port. When removing the connector, press the
latch, then pull plug out.
USB ports for connecting passive USB 2.0 devices
(e.g., Brainlab USB Flash Disk) for patient data transfer.
Connect digital input from SD or HD SDI source or a
composite (CVBS) source via a 5 m coaxial cable with
BNC connector to interact with Brainlab software video.
Push the male connector over the female connector, so
that the two small knobs on the female connector lock
into spiral slots in the male connector. Twist the bayonet
shell clockwise to lock the connector.
To remove the cable, twist the bayonet shell on the
male connector counter-clockwise, then pull plug out.
Connect Camera Cart with Brainlab camera cable via
LEMO connection.
Plug in the camera cable until it locks. Pull slightly at the
connector to verify locking. To unlock the connector, pull
the bayonet back to unlock the connector, then pull plug
out.
Serial communication port (female SUBD 9 pin cable).
Always fix the screws to lock the cable connector.
System User Guide Rev. 1.0 Curve Dual Display, Curve Single Display Ver. 1.0