Mounting Of Battery - Mitsubishi Electric MELSEC Q Series User Manual

4 SET-UP AND PROCEDURE BEFORE OPERATION

4.10.2 Mounting of battery

4 - 72
At shipment, the battery connector is not mounted to the battery of the Web server
module. Before using the Web server module, connect the battery connector.
(1) Open the cover at the bottom of the Web server module.
(2) Confirm that the battery has been mounted correctly.
(3) Insert the connector attached to the battery to the connector pin on the case.
Battery
Important
When operating the Web server module without the battery, make sure to perform
the shut-down operation described in Section 4.11.
Failure to observe the above procedure may cause erasure of logging data during
processing, corruption of data in the standard ROM drive/CompactFlash card
during access, or a file system fault.
POINT
Firmly push the battery connector all the way in to the connector pin.
Battery connector
MELSEC-Q
4 - 72