Mitsubishi Electric MELSEC Q Series User Manual page 489

9 TROUBLE SHOOTING
Error
Error name
code
Logging specification
0632h
error
Logging time setting
0633h
error
Logging storage
0634h
setting error
Logging capacity
0635h
setting error
Number of saved files
0636h
setting error
CPU event historical
0637h
data number error
Tag event historical
0638h
data number error
Time/Interval monitor
0639h historical data number
error
063Ah No specified CPU error
CPU event interval
063Bh
setting error
CPU event condition
063Ch
setting error
CPU event monitor
063Dh
attached file error
Tag event monitor tag
063Eh
non-setting error
9 - 34
Error definition
Invalid setting was made in
"Timing" of the logging setting, or
the logging setting file is
destroyed.
Invalid setting was made in
"Time/Interval specification" of the
logging setting.
Invalid setting was made in "Save
in" of the logging setting, or the
logging setting file is destroyed.
Invalid setting was made in "File
capacity" of the logging setting.
Invalid setting was made in "No. of
saved files" of the logging setting.
Invalid setting was made in "No. of
CPU event historical data" of the
event setting.
Invalid setting was made in "No. of
tag event historical data" of the
event setting.
Invalid setting was made in "No. of
time/interval event historical data"
of the event setting.
The access target CPU specified
in the CPU event setting does not
exist, or the access target CPU
has been deleted.
Invalid setting was made in
"Interval" of the CPU event setting.
Invalid setting was made in
"Condition" of the CPU event
setting, or the event setting file is
destroyed.
Invalid setting was made in
"Attached file" of the CPU event
setting.
The tag specified in "Tag name" of
the tag event setting does not
exist.
(From the previous page)
Corrective action
 After initializing the module (refer
to Section 4.13), perform the
logging setting (refer to Section
6.4.4) again.
 Check the logging setting.
(Refer to Section 6.4.4)
 After initializing the module (refer
to Section 4.13), perform the
logging setting (refer to Section
6.4.4) again.
 Check the logging setting.
(Refer to Section 6.4.4)
 Check the logging setting.
(Refer to Section 6.4.4)
 Check the event setting
(Common setting).
(Refer to Section 6.5.3)
 Check the event setting
(Common setting).
(Refer to Section 6.5.3)
 Check the event setting
(Common setting).
(Refer to Section 6.5.3)
 Specify the existing access target
CPU.
 Check the CPU event setting.
(Refer to Section 6.5.3)
 After initializing the module (refer
to Section 4.13), perform the
event setting (refer to Section
6.5.3) again.
 Check the CPU event setting.
(Refer to Section 6.5.3)
 Check the tag event setting.
(Refer to Section 6.5.3)
(Continued on the next page)
MELSEC-Q
Error type
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
Stop
9 - 34