Mitsubishi Electric MELSEC Q Series User Manual page 461

9 TROUBLE SHOOTING
Symptom
Device test cannot be
conducted.
Device test failed.
Tag component test
cannot be conducted.
Tag component test
failed.
Symptom
Created user HTML is
not displayed.
9 - 6
(4) Troubleshooting on device test and tag component test
Check point
The account without device write authority
was used to access.
Device write disable status is ON (YA is on).
Device test was not performed for the
devices of RCPU which do not exist in
QCPU or C Controller module.
The account without tag component write
authority was used to access.
Device write disable status is ON (YA is on).
"Data write" in the tag setting has been set to
"Disable".
Tag component test was not performed for
the devices of RCPU which do not exist in
QCPU or C Controller module.
(5) Troubleshooting on user HTML
Refer to (3) in this section as well.
Check point
The URL is not correct.
The created user HTML is not stored.
The applet size in the applet part is not
correct.
Corrective action
 Access using the account with device write
authority. (Refer to Section 4.6.5)
 Enable Device write (turns off YA).
 Access the devices within the range that
can be set for QCPU or C Controller
module.
 Access using the account with tag
component write authority. (Refer to
Section 4.6.5)
 Enable Device write (turns off YA).
 Set "Data write" in the tag setting to
"Enable". (Refer to Section 6.3.3)
 Access the devices within range that can
be set for QCPU or C Controller module.
Corrective action
 Check the URL.
 Store the created user HTML via FTP.
 Specify the correct applet size.
(Continued on the next page)
MELSEC-Q
9 - 6