Mitsubishi Electric MELSEC Q Series User Manual page 512

APPENDICES
File register
Link direct
device
Module
access
device
Refresh
data
register
App - 8
Device 1
(Device name)
(R)
(ZR)
(ERn\R) 5 10
Link input (Jn\X) 6
Link output (Jn\Y) 6
Link relay (Jn\B) 6
Link special relay (Jn\SB)
6
Link register (Jn\W) 6
Link special register (Jn\SW)
6
Intelligent function module
device (Un\G) 7
(U3En\G)
Cyclic
15
transmission
area device
(U3En\HG)
12
14
Refresh data register
(RD) 14
1 The local devices and the file registers for individual programs of the Q/QnA series
programmable controller CPU are not accessible by specifying the program name.
Do not use the local device and file registers for individual programs since correct
read/write may not be available.
2 Specify SM for the QCPU (Q mode)/QnACPU, or specify M9000 or later for the QCPU
(A mode)/ACPU.
3 Specify SD for the QCPU (Q mode)/QnACPU, or specify D9000 or later for the QCPU
(A mode)/ACPU.
4 The device name can be specified by using either symbol.
5 Specify the block number for "n".
6 Specify the network No. for "n".
7 Specify the I/O number of the intelligent function module/special function module for
"n".
8 Not accessible when the Q00JCPU is used.
9 The M, L and S devices are in the same area independently of the device setting in
the parameters.
10 ER0\R cannot be specified.
11 The device can be accessed only when [Use device function] is selected on the
device setting screen in the C Controller setting utility.
12 The device is for a multiple CPU system only.
QCPU QCPU
RCPU 16
(Q mode) (A mode)
8
8
MELSEC-Q
(From the previous page)
LCPU QnACPU ACPU
: Accessible, : Inaccessible
App - 8
C
Controller
module