Section 3.0 Table Cover Installation (Gt1700V); Side Covers; Install Panels; Top Panel #1 - GE Optima CT680 Series Installation Manual

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
3.) Install four screws (two screws on each side).
Figure 4-16 Install Front Cover Screws

Section 3.0 Table Cover Installation (GT1700V)

3.1

Side Covers

1.) Remove screws (2) on tape switch.
2.) Remove back under-side covers (2) plus black screws.
3.) Undo the 2 red/black connectors.
4.) Remove all six (6) 4mm hex-head screws.
3.2

Install Panels

3.2.1

Top Panel #1

1.) Install two (2) 4mm hex-head screws. Leave them loose until the bottom screws are installed.
2.) Install 6nd wire using one (1) 4mm hex-head screw.
3.2.2

Bottom Panel #1

1.) Install white washer between grey base and panel. Insert Phillips screw into the bushing.
2.) Tighten top screws. (Torque 8 lb-in)
Note: Second panel over laps the first panel
6
Chapter 4 - System Covers: Installation & Alignment
O CT680 S O
PTIMA ERIES AND PTIMA
CT670 I M
NSTALLATION ANUAL
Page 153