GE C
OMPANY
D
5472001-1EN, R
IRECTION
EVISION
Rear Cover Removal
CAUTION
Pinch Hazard
Uncontrolled cover movement
Make sure the wing nuts are tightened on the cover dollies prior to releasing cover from
gantry mounts.
1.) Install the rear cover dolly.
a.) Tighten the two (2) shoulder bolts to the rear cover. Use the extending bolt for the upper
b.) Fit side dolly through the shoulder bolts and secure assembly with two (2) wing nuts.
c.)
2.) Remove rear cover by removing 8 screws, which attach the rear cover to the brackets.
Figure A-34 8 Screws of Rear Cover
Figure A-35 Removed Rear Cover
3.) Move cover away from gantry as needed.
6
side.
Repeat steps a and b for the other side dolly.
Appendix A – Gantry Cover Removal and Dolly Setup
O
CT680 S
O
PTIMA
ERIES AND
PTIMA
CT670 I
M
NSTALLATION
ANUAL
Page 187