GE Optima CT680 Series Installation Manual page 57

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
9.3.3 Table Cover Removal
1.) Remove the table right side cover, as shown in
a.) Removing the two screws on each end of the underside of the long side cover of the table.
b.) Slide each cover forward to unlatch, lift upward slightly to disengage the latches, and
Vertical Panel - Top
Figure 1-30 Table Covers
2.) The table is normally shipped with some of the side/vertical panels removed. If installed,
remove the four side panels, using a Pozi drive #1 screwdriver.
3.) Carefully lay the side panels on protective padding out of the way.
4.) Make sure that all four of the table levelers are on the floor. The table should set on the four
levelers with the dollies still installed.
5.) Carefully center the four levelers over the 4" (102mm) floor cutouts.
6.) Check that the front table base center line is on the chalk table center line.
7.) If still present, remove all packing materials and the table cradle pad from the table cradle.
Front Base Cover
(in front of table base)
Figure 1-31 Table Covers
6
remove the side cover. Doing this procedure will require patience and practice to remove
and replace this cover.
Vertical Panel - Bottom
Left and Right
Base Covers
Chapter 1 - Position Subsystems
O CT680 S O
PTIMA ERIES AND PTIMA
Figure 1-31.
Right Table Cradle Side Cover
Left and Right
Vertical Side Covers
CT670 I M
NSTALLATION ANUAL
Table Side Cover Screws
Left and Right
IMS Covers
Page 57