GE Optima CT680 Series Installation Manual page 56

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
1.) Remove all the transportation packaging and boxes, except dollies, from the table. (See
Figure 1-27 Remove Table Packing
2.) Unpack the items and locate all of the items needed to install the table.
Note: The GT / VT table on dollies is approximately 118" long and may require additional room to
maneuver.
3.) Using the table centering and distance locator marks made earlier, wheel the table to its
4.) Locate the table leveling pads inside the table in the back and on the side in the front. Preset
Figure 1-28 Table Base Leveling Pads (Starting Positions)
5.) Use a 1-5/8" socket and ½" ratchet to loosen the shipping bolt. Loosen the locking rings if
6.) A 1-1/8" socket is used with the adjuster tool if needed to lower the adjuster.
7.) Use the dollies to evenly lower the table until it rests on the leveling pads using a ½"ratchet on
Figure 1-29 Adjusters and Lock Rings
Page 56
6
Figure 1-27.) Leave a layer of packing material on the cradle to protect the cradle from
damage. (It can be removed during laser alignment of the table.)
approximate position relative to the gantry.
leveling pad heights to 5/8" (15.5mm). (See Figure 1-22.)
present.
each end.
Back
Section 9.0 - Table Installation (GT1700V)
O CT680 S O
PTIMA ERIES AND PTIMA
CT670 I M
NSTALLATION ANUAL
Front