GE Optima CT680 Series Installation Manual page 38

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
11.) Cut tiles (or other resilient flooring) around all holes punched in the template for the gantry and
Note: A fast way to remove flooring is to use a 4 in. hole saw with a 1/4 in. masonry bit to cut through the
flooring at each leveler pad location.
12.) Some sites require sealing of the floor penetrations after the flooring is removed. If this site
NOTICE All documentation in this manual is based on mounting the table/gantry on a 102 mm (4 in.)
- 110mm (4-1/3 in.) concrete floor.
13.) Snap a chalk line using the marks that were made on the tape at the ends of the table template.
Page 38
6
table.
does, use RTV or other sealant to seal the floor covering as necessary.
Section 4.0 - Layout the Floor Template
O CT680 S O
PTIMA ERIES AND PTIMA
CT670 I M
NSTALLATION ANUAL