GE Optima CT680 Series Installation Manual page 173

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
IN PERSONAL INJURY OR DAMAGE TO COVERS OR OTHER FACILITY ITEMS.
ONLY USE DOLLIES ON FLAT SURFACES..
CAUTION Rotating arms on the stand are supposed to be stiff. If they fall freely, tighten the tensioning
nuts. Loose rotating arms will reduce the stability of the dollies when supporting the front
cover. Do not lubricate.
1.) Arrange Dolly sections for assembly. The base and post can be assembled only one way.
Refer to
-
-
-
-
Top Post
Base
Figure A-8 Front Cover Dolly in Storage Mode
Top Plate
Figure A-9 Front Cover Dolly Base Assembly
2.) Unfold the base legs by loosening both palm screws to the top of their travel.
3.) Carefully unfold the legs so that the castors touch the floor.
4.) Tighten the palm screws to clamp the legs between the base top and bottom plates.
Note: Lifting the base by the riser post while leaving the castors on the floor will ease palm screw
tightening. Reference
WARNING EQUIPMENT TIP HAZARD
COVER DOLLIES MAY TIP OVER IF NOT CONFIGURED PROPERLY.
ENSURE BOTH PALM SCREWS ARE TIGHTENED SECURELY AND THE LEGS
ARE CLAMPED TIGHTLY BETWEEN THE BASE TOP AND BOTTOM PLATES.
6
Figure A-8 and Figure
The base uses two (2) palm screws to clamp the four (4) legs in the open or usage mode.
The base also uses the same palm screws to prevent the legs from falling in storage mode.
The top post can be inserted in either base and is keyed for proper engagement.
The top post locking pin prevents the sections from separating during usage.
Bottom Plate
Figure A-9.
Appendix A – Gantry Cover Removal and Dolly Setup
O CT680 S
PTIMA ERIES AND
A-9.
Base
Riser
Post
Palm Screws
Table Side
O CT670 I M
PTIMA NSTALLATION
Gantry
Side
Page 173
ANUAL