Procedure - GE Optima CT680 Series Installation Manual

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
-
Figure 3-4 Correct - Head Holder is latched onto first step of plastic latch mechanism (The
head holder does not need to be latched onto the second step)
Figure 3-5 Wrong - Head Holder is NOT latched after installing shims
3.4

Procedure

1.) First place the two 4.0mm shims (thickest size) onto both edges of the head holder as shown
(use a piece of tape to temporarily secure them)
-
-
Figure 3-6 Headholder Tab
2.) Insert the head holder into the cradle
3.) Check if the head holder is latched onto the cradle at the first step of the plastic latch
6
Damage to the plastic latch or the plastic screws that secure it.
The shim must be placed with the tab facing out
The thickness is printed on the shim
Chapter 3 - System Continuity & Ground Checks
O CT680 S O
PTIMA ERIES AND PTIMA
CT670 I M
NSTALLATION ANUAL
Page 139