GE Optima CT680 Series Installation Manual page 87

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
7.) Cut the tie-wraps from around the cables in the gantry base and route the power cables from
the gantry as shown in
M4 cap
screws
Figure 1-69 Footswitch Assembly Cable Wiring
8.) Connect the ground bus connector plate.
Note: Additional M6 Hex-screws may be required to connect grounds.
6
Figure 1-69.
Chapter 1 - Position Subsystems
O CT680 S O
PTIMA ERIES AND PTIMA
Connect cable connector to J9,
GND cable to table frame
and power to power connector.
Ground Bus
CT670 I M
NSTALLATION ANUAL
Page 87