GE Optima CT680 Series Installation Manual page 41

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
Figure 1-6 Gantry and Table Base Leveling Pads (Starting Positions)
NOTICE Gantry dollies weigh approximately 250 lbs each. Exercise caution when removing
dollies so as to not damage the floor covering.
6.) Using a 14mm hex socket, remove the dollies from the gantry by removing the three dolly bolts
found at both ends of the gantry
Figure 1-7 Gantry Dolly Bolts
7.) Remove the dolly plates on both sides of the gantry. Retain the dolly plates in the service
cabinet at the hospital.
Figure 1-8 Dolly Plate
6
Chapter 1 - Position Subsystems
O CT680 S
PTIMA ERIES AND
(Figure 1-7).
O CT670 I M
PTIMA NSTALLATION
Page 41
ANUAL