GE Optima CT680 Series Installation Manual page 52

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
Figure 1-21 Alignment Bar Installation Location
CAUTION Potential for injury.
DO NOT look into the laser.
Use appropriate safety procedures when working with lasers.
7.) Attach the laser centering plate onto the laser mounting bar as shown in
Figure 1-22 Attach Laser Center Plate
8.) When done, insert the laser and turn on the laser using the controls on the back.
Page 52
6
- Do not drop bolts or the bar on the collimator faceplate. Attach the bar as shown in
Figure 1-21.
- Using a minimum 223 mm (9 in.) level placed on the attached bar, level the bar by rotating
the gantry.
is attached from under the alignment bar using two fixed locators and two thumb screws.
If the laser is loose when mounted, use a 2 in. piece of Velcro loop (fuzzy) section and attach
it to the alignment plate over the attachment screw. Remount the laser and it should fit snugly
without moving.
Section 8.0 - Install Gantry Alignment Laser and Bracket
O CT680 S
PTIMA ERIES AND
M10
Thumb screws
Alignment tabs (right tab not shown)
O CT670 I
PTIMA NSTALLATION
Figure 1-22. The plate
Laser
Mounting
Screw
M
ANUAL