GE Optima CT680 Series Installation Manual page 51

GE C
OMPANY
D 5472001-1EN, R
IRECTION EVISION
4.) Remove two (2) bottom bore cover screws and loosen the top bore cover screw.
Figure 1-19 Bore Cover Screws
5.) Slide the bore cover about 5 cm (2 in.) so that the laser tool can be attached.
Figure 1-20 Sliding Bore cover backward
6.) With the Gantry top, rear, and bore covers removed, locate the two M10 bolt holes as shown
in
-
6
Figure 1-21. These bolt holes are used to attach the laser tool to the gantry.
The bolts can be installed using an 8 mm Allen wrench. Be careful not to bump the
alignment light; the mounting space is tight near the alignment light. Tighten bolts until
both are snug.
Chapter 1 - Position Subsystems
O CT680 S O
PTIMA ERIES AND PTIMA
CT670 I M
NSTALLATION ANUAL
Page 51