Outline Of Installation, Wiring And Maintenance; Installation, Wiring And Maintenance Procedures - Mitsubishi A1SD75P1-S3 User Manual

4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT

4.1 Outline of installation, wiring and maintenance

4.1.1 Installation, wiring and maintenance procedures

The outline and procedures for AD75 installation, wiring and maintenance are shown
below.
STEP 1
Preparation Refer to
section 4.1
STEP 2
Installing the
Refer to
module
section 4.2
STEP 3
Refer to
section 4.3
Wiring the
module
STEP 4
Refer to
section 4.3
STEP 5
Refer to
Confirming the
section 4.4
installation and
wiring
STEP 6
Operation of the positioning system.
STEP 7
Refer to
section 4.5
Servicing the
module
STEP 8
Refer to
section 4.5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Understand the "Handling precautions" and
"Names of each part" of the module (AD75)
Install the module (AD75) on the base unit.
Wire the external device connection
connector pins, and assemble the connector.
Connect the cable to the module (AD75)
Carry out the single module test
Confirm the connection
Carry out maintenance
Dispose of the AD75
4 - 2
MELSEC-A
The cables used to connect the AD75 with the drive
*
unit, the AD75 with the machine system input (each
input/output signal), and the AD75 with the manual
pulse generator are manufactured by soldering each
signal wire onto the "external device connection
connector" enclosed with the AD75.
Wire and connect the manufactured cable to AD75
after reading the precautions for wiring.
Confirm that the AD75 functions properly
*
with the single module test.
* Check the connection using the GX Configurator-AP.
* Carry out maintenance as necessary.
* When the AD75 is no longer necessary,
dispose of it with the specified methods.