Mitsubishi A1SD75P1-S3 User Manual page 166

5 DATA USED FOR POSITIONING CONTROL
[Table 1]
Pr.11
setting value
0 : Standard mode
1 : Stepping motor
mode
[Table 2]
Da.2
setting value
JUMP command
Other than JUMP command* : 01
[Table 3]
Da.2
setting value
JUMP command
Other than JUMP command* : 01
* Setting is not required at the actual value modification (11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Pr.1
Value set with peripheral device (unit)
setting value
0 : mm 0.01 to 6000000.00 (mm/min)
1 : inch 0.001 to 600000.000 (inch/min)
2 : degree 0.001 to 600000.000 (degree/min)
3 : pulse 1 to 1000000 (pulse/s)
0 : mm 0.01 to 375000.00 (mm/min)
1 : inch 0.001 to 37500.000 (inch/min)
2 : degree 0.001 to 37500.000 (degree/min)
3 : pulse 1 to 62500 (pulse/s)
Setting item
: 20 Positioning data No.
H
to 10 Dwell time
H H
Setting item
: 20 Condition data No.
H
to 10 M code
H H
1 to 600000000 ( × 10
1 to 600000000 ( × 10
1 to 600000000 ( × 10
1 to 1000000 (pulse/s)
1 to 37500000 ( × 10
1 to 37500000 ( × 10
1 to 37500000 ( × 10
1 to 62500 (pulse/s)
Value set with peripheral
device
1 to 600
0 to 65535 (ms)
Value set with peripheral
device
0 to 10
0 to 32767
).
H
5 - 69
MELSEC-A
Value set with sequence program
(unit)
-2
mm/min)
-3
inch/min)
-3
degree/min)
-2
mm/min)
-3
inch/min)
-3
degree/min)
Value set with sequence
program
1 to 600
0 to 65535 (ms)
Value set with sequence
program
0 to 10
0 to 32767