Mitsubishi A1SD75P1-S3 User Manual page 532

14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
0 150 300
1 151 301
2 152 302
3 153 303
4 154 304
5 155 305
6 156 306
7 157 307
8 158 308
9 159 309
10 160 310
11 161 311
12 162 312
13 163 313
16 166 316
17 167 317
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting range
(Setting given in sequence program)
0, 1, 2, 3
1 to 65535
1 to 65535
1, 10, 100, 1000
0, 1, 2, 3
0, 1
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
(One-word type) 1 to 65535
(Two-word type) 1 to 8388608
(One-word type) 1 to 65535
(Two-word type) 1 to 8388608
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
(In standard mode)
• [mm] [inch] [pulse]
-2147483648 to 2147483647
• [degree] 0 to 35999999
(In stepping motor mode)
• [mm] [inch] [pulse]
–134217728 to 134217727
• [degree] 0 to 35
14 - 21
Remedy
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
• Change the setting to within the setting range.
• In case of a unit other than "degree," change the settings
so that the lower limit value is smaller than the upper limit
value.
MELSEC-A