Table of Contents
Advertisement
FX-10DM-E DISPLAY MODULE
3.
Installation, Wiring and Maintenance
This section describes the panel processing, installation and wiring procedures for the 10DM.
3.1
Installation
The 10DM is to be embedded on the panel face. Install it using the following procedure.
1) Dimensions inside the panel required for installation
Consider the dimensions inside the panel shown in the
right, then process the mounting panel face and install
the 10DM.
a) PLC connection cable
b) Packing
c) Bracket
2) Processing the mounting panel face
Drill the rectangular area shown in the left on the panel face.
At this time, as shown in the figure in 1) above, the space for
brackets (10 mm) is required above and below the mounting
area.
* Make sure that the mounting panel face thickness is 5 mm
or less.
Installation, Wiring and Maintenance 3
c)
a)
86
Panel cut area
+1
87
0
3-1
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
32
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
b)
5 ms
or less
"OTHER"
49
6.Display
"ENTRY
Unit: mm
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list
Advertisement
Table of Contents
