Mitsubishi A1SD75P1-S3 User Manual page 306

9 MAIN POSITIONING CONTROL
(1) Independent positioning control (Positioning complete)
Positioning start signal
Start complete signal
BUSY signal
Positioning complete signal
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This control is set when executing only one designated data item of positioning. If
a dwell time is designated, the positioning will complete after the designated time
elapses.
This data (operation pattern [00] data) becomes the end of block data when
carrying out block positioning. (The positioning stops after this data is executed.)
[Y10, Y11, Y12]
OFF
[X1, X2, X3]
OFF
[X4, X5, X6]
OFF
[X7, X8, X9]
OFF
Fig. 9.1 Operation during independent positioning control
9 - 5
Positioning complete (00)
ON
ON
ON
MELSEC-A
Dwell time
Time
ON