Mitsubishi A1SD75P1-S3 User Manual page 272

7 MEMORY CONFIGURATION AND DATA PROCESS
(B) Setting positioning data No. 101 to 600 data
From peripheral device
Set the data following the
peripheral device menu
Write the data set with the peripheral
device into the OS memory
[Transmission process (10)]
* The details written with the TO command are shown below.
Block 5100 Target axis (1: axis 1, 2: axis 2, 3: axis 3)
transmission
5101 Head positioning data No. (1 to 600)
memory
5102 No. of read/write data (1 to 100)
Read/write request
5103
0: Read/write complete (set by OS)
1: Read request
2: Write request
Read/write block
5110
(Positioning data storage area)
to
6109
* The default value is "0".
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The positioning data is set with the following procedures.
Using sequence program (brock transmission)
No.1 to 100
Write positioning data into buffer
memory using TO command
[Transmission process (3)]
Complete
7 - 13
No.101 to 600
Positioning data
Turn OFF the PLC READY
signal [Y1D]
Write required positioning data into buffer memory's block
transmission area [5110 to 6109] using TO command.
Write following items into buffer memory's block
transmission area [5100 to 5103] using TO command:
* Axis that sets positioning data
* Head No. of positioning data to be set
* Size of positioning data to be set
(Up to 100 items can be set at once)
* Setting of write/read
The positioning data set in the block transmission
area [5110 to 6109] is written into the OS memory.
Set data size
Which axis
From nth positioning data in OS memory
How many data
Whether to read or write
When reading, the data is read from the OS
memory into here, and when writing, the data set
and stored here is written into the OS memory.
MELSEC-A
[Transmission process (6)]
*
[Transmission process (6)]
101 items or more
100 items or less
• • • User work
• • • AD75 state