Mitsubishi A1SD75P1-S3 User Manual page 77

4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
No. Name
1) 17-segment LED
2) Axis display LED (AX1 to 3)
3) Mode switch
4) Module version label
Peripheral device connection
5)
connector
External device connection
6)
connector
Each AD75 interface is as shown below.
AD75P1-S3
RS-422
AX1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Display the operating status (1)) of the target axis (2)) for that axis.
RUN : The LED corresponding to the operating axis flickers.
TEST : The LEDs of all axes turn ON.
IDL : OFF
ERR : The LED corresponding to the axis in error flickers.
Each time this switch is pressed, the details displayed on "1) 17-segment LED" and
"2) Axis display LED" will change.
[Display details]
Operation monitor 1
Stepping motor mode
Input/output information n
(Refer to section "13.4 LED display function" for details on the displayed
information.)
This label indicates the module's software version and hardware version.
(Example)
A B
Indicates that software version is "B".
Indicates that hardware version is "A".
Connector for connecting with peripheral device.
Connector for connecting drive unit, mechanical system input and manual pulse
generator.
AD75P2-S3 AD75P3-S3
RS-422 RS-422
AX1 AX1
AX2
AX3 AX2
4 - 4
Details
Operation monitor 2
Internal information 1
Internal information 2
A1SD75P1-S3 A1SD75P2-S3
AX1
MODE
RS-422
AX1
AX2
A1SD75P1-S3 A1SD75P2-S3
MELSEC-A
A1SD75P3-S3
AX1
MODE MODE
RS-422 RS-422
AX2 AX3
A1SD75P3-S3