Husky Altanium Matrix5 User Manual page 238

6.
Figure 15-40 HDMI-to-DVI Extension
7.
WARNING!
The cables should be routed in accordance with local codes. This includes areas free of
debris and liquids and away from sharp edges or objects that can pinch or cut the cable
housing or conductors. The cables should not be bent at a radius less than 4x the outer
diameter of the cables. Ensure that the cables are routed in areas where the ambient
temperature is within a range of -10 °C to 60 °C (14 °F to 140 °F). It is also recommended
that the cables are routed away from other cables, especially those that are high
voltage or high frequency, to minimize signal interference.
Figure 15-41 Route Cables
226
Connect the HDMI end of the HDMI-to-DVI Extension cable to the HDMI connector end
of the DisplayPort to HDMI Converter. Refer to
Route the USB and HDMI-to-DVI Extension cables from the MCU to the location of the
secondary touch monitor. Refer to
v 1.0 — February 2020
Figure
Figure 15-41.
Altanium Matrix5
15-40.
Install the Dual Touch Monitor