Chapter 8: Mold Diagnostics; Testing The Mold - Husky Altanium Matrix5 User Manual

User Guide
Chapter 8
Mold diagnostics is used to troubleshoot problems with a mold and to make sure that the
wiring integrity of a mold after maintenance has been done. Diagnostics can also be used to
analyze the thermal isolation between all the cavities in the mold.
8.1

Testing the Mold

To test the mold, do the steps that follow:
1.
2.
3.
4.
5.
Figure 8-1
1. Run Test 2. Stop Test 3. View Test Results
Testing the Mold
Mold Diagnostics
On the Home screen, touch the Mold Diagnostics button.
The Mold Diagnostics screen shows. Refer to
Make sure that the Altanium system is in the Stop state.
Select the zone(s) to be tested.
Select the check box(es) for the test(s) to be done.
Touch the Run Test button.
Mold Diagnostics Screen
v 1.0 — February 2020
Figure 8-1.
Mold Diagnostics
83