Boost Timer Settings; Set The Manual Boost Duration Timer; Set The Remote Boost Duration Timer - Husky Altanium Matrix5 User Manual

Table 10-9
Manual
Time
----
----
----
To cancel the remote standby duration timer, touch the Start or Stop buttons.

10.18 Boost Timer Settings

To increase the temperatures in the mold for a specified period of time, set the boost timers
related with each boost function. When the system enters Boost, the timer starts. When the
timer completes, the temperatures decrease back to the setpoint.

10.18.1 Set the Manual Boost Duration Timer

Use the Manual Boost Duration Timer to set a duration period for the zones to heat up to the
manual boost setpoint limit.
To set the Manual Boost Duration Timer, do the steps that follow:
1.
2.
3.
4.

10.18.2 Set the Remote Boost Duration Timer

The input option settings make the decision how the system reacts when it receives the
remote boost input.
NOTE:
132
Remote Standby Operational Description (Continued)
Delay Remote
Time Time
X:XX:XX X:XX:XX
X:XX:XX 0:00:00
---- ----
On the System Setup screen, touch the Heats Setup tab and then touch the Control
Page 1 tab.
Touch the Manual Boost Duration Timer field that is below Manual Standby and Boost.
Enter the time requirement in this format: HHMMSS.
Touch the Accept button.
If remote boost is not installed on the system, only the Manual Boost Duration Timer
field is shown on the screen.
v 1.0 — February 2020
Input Cycle
Mode Enabled
ON/OFF ----
ON/OFF ----
Direct ----
Operation - STANDBY Button Select
System delays for a specified time and
then enters Standby until the signal is
not active or the timer completes.
System delays for a specified time and
then enters Standby until the input
signal is not active.
System enters Standby until the input
signal is not active. If the input signal is
active when the system is started, it
will immediately go into Standby
mode.
Boost Timer Settings
Altanium Matrix5