Husky Altanium Matrix5 User Manual page 226

Figure 15-21 Operator Interface Screw Removal
5.
Figure 15-22 Remove the Operator Interface
6.
7.
8.
9.
10. Connect the Power and Communication connectors that come from the controller
214
Securely hold the operator interface at the silver mounting pole and carefully lift the
unit from the top of the mainframe. Refer to
When you install the replacement operator interface, securely hold the operator
interface at the silver mounting pole when you lift it.
Put the operator interface on the top of the mainframe.
Align the four screw holes in the base plate with the holes in the top of the mainframe.
Install the four screws and tighten them with a #4 Phillips screwdriver.
NOTE: This step will require a screw driver short enough to clear the MCU located above
the two back mounting screws.
mainframe to the bottom of the MCU enclosure.
v 1.0 — February 2020
Figure 15-22.
Remove and Replace the Operator Interface
Altanium Matrix5