Table 12-5
Cycle Mode - Conditions to Stop (UltraSync-E or Altanium Servo Control Installed)
UltraSync-E
Heats Running
Engaged
Condition
Condition
Enabled
Enabled
Yes
Yes
170
v 1.0 — February 2020
Mold Servo
Cycle Mode
Controller
Conditions
Engaged
Selection Shown
Condition
on Screen
Enabled
No
Yes
Conditions to Stop
If pair of digital inputs (start and end)
•
End digital input does not go high before the
cycle time limit has expired
•
Heats are turned off or not At Temperature
•
UltraSync-E is disengaged or disabled
System changes to timed data collection
If one digital input to start and timer to end data
collection:
•
Start digital input is not high again before the
cycle time limit has expired
•
Heats are turned off or not At Temperature
•
UltraSync-E is disengaged or disabled
System changes to timed data collection
If one digital input to start and end data collection:
•
Start digital input does not go high again
before the cycle time limit has expired
•
Heats are turned off or not At Temperature
•
UltraSync-E is disengaged or disabled
System changes to timed data collection
Altanium Matrix5
Data Collection Stop Conditions