Remote Load - Husky Altanium Matrix5 User Manual

10.7 Remote Load

Mold setups can be loaded directly from the injection molding machine. With the Remote
Load option, the injection molding machine can send a signal to the controller on one of up
to 1023 input combinations to identify which mold setup to load. The system uses
combinations of:
•
•
•
To set up Remote Load, do the steps that follow:
1.
2.
Figure 10-8
3.
4.
122
Six binary inputs - lets the user assign a mold setup to each one of 63 possible
combinations.
Eight binary inputs - lets the user assign a mold setup to each one of 255 possible
combinations.
Ten binary inputs - lets the user assign a mold setup to each one of 1023 possible
combinations.
On the System Setup screen, touch the Heats Setup tab and then the Control Page 2
tab.
Touch the Setup button below Remote Load.
The Remote Load - Setup dialog window shows. Refer to
Remote Load - Setup Dialog Window
Touch the Remote Load Enable check box so the check mark shows.
Touch the Configure Digital I/O button if the Digital I/O configuration was not done
before.
The Digital I/O screen shows. Refer to
the digital inputs/outputs.
v 1.0 — February 2020
Section 13.1
Figure 10-8.
for information on how to configure
Altanium Matrix5
Remote Load