Controller Lifting Instructions - Husky Altanium Matrix5 User Manual

User Guide
1.8

Controller Lifting Instructions

Use the steps that follow when you lift the Altanium controller. The lift device (crane or
forklift) and straps that are used vary in lifting ability and lengths, depending on whether the
Altanium is a single, double, or triple stack controller. See the table that follows for the correct
lifting ability and lengths.
Altanium Controller
Single Stack
Double Stack
Triple Stack
1.
2.
Figure 1-1
Controller Lifting Instructions
Webbed Straps Rated 2903
Two, 2.44 m x 25.4 mm
(8 ft x 1 in.)
Two, 3.66 m x 25.4 mm
(12 ft x 1 in.)
Two, 3.66 m x 25.4 mm
(12 ft x 1 in.)
Put each of the webbed straps under the controller. See the table for the correct strap
lengths.
a. For single stack controllers, the webbed straps go under the equipment from left to
right.
b. For double and triple stack controllers, the webbed straps go under the equipment
from front to back.
Bring the straps up and above the Altanium controller and attach them to the lifting
device. Refer to Figure 1-1.
Attach Straps to Lift Device
a. Make sure that the straps are put between the caster wheels and the retaining
brackets under the base of the controller. Refer to
v 1.0 — February 2020
kg (6400 lb)
One, 1.52 m (5 ft)
One, 1.83 m (6 ft)
One, 2.44 m (8 ft)
Lifting Device (Lifting
Ratchet Strap
227 kg (500 lb)
454 kg (1000 lb)
907 kg (2000 lb)
Figure 1-2.
Introduction
Ability)
5