Husky Altanium Matrix5 User Manual page 183

User Guide
Table 12-5 Cycle Mode - Conditions to Stop (UltraSync-E or Altanium Servo Control Installed) (Continued)
UltraSync-E
Heats Running
Engaged
Condition
Condition
Enabled
Enabled
Yes No
Data Collection Stop Conditions
v 1.0 — February 2020
Mold Servo
Cycle Mode
Controller
Conditions
Engaged
Selection Shown
Condition
on Screen
Enabled
Yes Yes
Conditions to Stop
If pair of digital inputs (start and end):
• End digital input does not go high before the
cycle time limit has expired
• Heats are turned off or not At Temperature
• Mold Servo Controller is disengaged or
disabled
System changes to timed data collection
If one digital input to start and timer to end data
acquisition:
• Start digital input is not high again before the
cycle time limit has expired
• Heats are turned off or not At Temperature
• Mold Servo Controller is disengaged or
disabled
System changes to timed data collection
If one digital input to start and end data
acquisition:
• Start digital input does not go high again
before the cycle time limit has expired
• Heats are turned off or not At Temperature
• Mold Servo Controller is disengaged or
disabled
System changes to timed data collection
Data Recording
171