Husky Altanium Matrix5 User Manual page 220

Figure 15-14 Retaining Bar and Cable Removal
7.
8.
IMPORTANT!
Only loosen the top fasteners. The top mounting holes in the bracket holding the touch
monitor are slotted and allow the monitor to be removed without removing the top
fasteners completely.
208
After the cables are clear of the retaining bar, disconnect the Power, Video (this
connector is held in by screws and may require a small slotted screwdriver for removal)
and Touchscreen connectors. Refer to number 4 in
Use a 4 mm right angle Allen key or hex wrench to remove the two bottom socket cap
screws from the retaining plate that secures the touch monitor to the pedestal. Refer to
number 5 in Figure 15-15.
v 1.0 — February 2020
Figure 15-14.
Remove and Replace the Touch Monitor
Altanium Matrix5