Connecting Steps; Powering On - Lightware MX2-4x4-HDMI20-CA User Manual


  
4. Installation
4.3. Connecting Steps
Connect the desired sources to the HDMI input ports.
Always use high-quality HDMI cables. Maximum cable lengths for inputs: 1920x1080@60Hz 4:4:4 - 40m;
3840x2160@30Hz 4:4:4 - 15m; 3840x2160@60Hz 4:4:4 - 5m
Optionally connect an audio source to the Audio input port which is located next to the connected HDMI
input port.
Connect the sink devices to the HDMI output ports.
Optionally connect an audio device (e.g. audio amplifier) to the Phoenix Audio output port which is located
next to the connected HDMI output port.
In order to control the matrix via Ethernet, connect the device to a LAN switch/router, and connect a
controller (e.g. a Touch panel).
Connect the power cord to the AC power socket and to the matrix.
MX2-HDMI20 series – User's Manual
4.3.1. Powering On
Connect the power cords to AC input of the Power Supply Units (PSU).
INFO: The router has an internal emergency memory that stores all current settings and tie configurations.
This memory is independent from presets and invisible for the user. This built-in feature helps the system
to be ready immediately in case of power failure or accidental power down.
1 RU-high models
The 1 RU-high models are immediately powered on. After the self-test (about 20
seconds), the router reloads its last configuration and it is ready to use.
Other models
Certain models are assembled with power button (see the details in the
Comparison
After switching the power switch to the ON position, the router starts up. If the
mains' switch is in the ON position, then the matrix starts up immediately when the
power cord is connected to the AC source. During the initial self-test and loading of
the latest settings, The matrix is about to start appears on the LCD screen and the
router reloads its last configuration.
INFO: After switching ON, the router reloads the latest settings that were used
before it was switched off. The router has an internal emergency memory that
stores all current settings and tie configurations.
Redundant Power Supplies
The -R suffix in the model name shows that the model has redundant PSUs which
can be switched on and off without interrupting the video transmission. Using the
only one or both the PSUs at the same time is also possible.
Double PSU allows to connect them for two different AC power lines to ensure the
continuous power for the matrix.
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
table).
34
Model