Advertisement
bizhub C4000i/C3300i
[1]
[1]
[1]
[2]
[1]
[2] [3]
11. To reinstall, reverse the order of removal.
12. Enter the model information after replacing the CPU board.
F.4.3.2 (1) Entering the machine type information
Actions after replacement of the board
1. Turn ON the main power switch.
2. The machine will reboot two times by itself. Wait until the trouble code (C-D3C0) screen appears.
3. [Recover Data] appears on the trouble code screen, touch [Recover Data] to start the recovery of data.
4. Check the firmware version of the Power Control CPU 2 and MFP Controller BOOT Program.
Firmware Version
5. If the firmware version of the Power Control CPU 2 and MFP Controller BOOT Program is not the latest, upgrade the firmware.
FIRMWARE
(1) Entering the machine type information
• When CPU board is replaced, it is necessary to enter the machine type information.
• Refer to the following procedures to enter the machine type information.
(a) Procedure
1. Insert the USB memory with the firmware into the USB port.
[2]
[1]
[4]
[1]
F DISASSEMBLY/REASSEMBLY > 4. bizhub C4000i/C3300i
6. Remove four screws [1], and remove the plate [2].
7. Remove five screws [1], and remove the plate [2].
8. Remove the harness from the wire saddle [1], and disconnect the connector
[2].
9. Remove two screws [3], and remove the CPU board [4].
NOTE
▪ When mounting the CPU board, insert it obliquely.
10. NOTE
▪ When replacing the CPU board, remove the microSD card [1], and
mount it onto the new CPU board.
F-19
Advertisement
