Advertisement
bizhub C4000i/C3300i
6. Administrator
6.1 Outline
NOTE
▪ The Administrator Settings will be available by entering the administrator password (16 digits) set by the Administrator Settings
or Service Mode. (The administrator password is initially set to "1234567812345678.")
▪ When [Administrator] -> [Security] -> [Enhanced Security Mode] is enabled, entering the incorrect administrator password three
times will cause access lock. The access lock is released after the lapse of a predetermined period of time (Default setting: 5
min.) after the main power switch is turned OFF and then ON more than 10 seconds later. The access lock can be released by
[Service Mode] -> [Enhanced Security] -> [Administrator unlocking].
6.2 Maintenance
Key name
Meter Count
ROM Version
Status Notification Setting
Total Counter Notification
Setting
Date/Time Setting
Daylight Saving Time
Timer Setting
Network Error Code Display
Setting
Reset
License Settings
-
-
-
-
Manual Setting
-
Time
When this setting is enabled, touch [Data Entry] and modify the time.
Adjustment
Setting
When this setting is enabled, set the time difference to move up.
• Default setting: 60 min.
• Setting range: 1 to 150
Power Settings
Low Power
Mode Setting
Sleep Mode
Setting
Power
Consumption
in Sleep
Mode
Power Save
Settings
Enter Power
Save Mode
Power Key
Setting
Weekly Timer
Use Weekly
Settings
Timer
Use Power
Save
Use Overtime
Password
Enable
Tracking
Function
-
Network Setting
-
Clear
Reset
-
Clear All
-
Address At
Once
Get Request Code
-
Install License
Function/Precondition
The upper limit can be set up to 240 min. only when the switch number
"157" is specified to "02" at HEX assignment by setting [Service Mode] ->
[System 2] -> [Software Switch Setting].
• When [Service Mode] -> [System 1] -> [Sleep ON/OFF Choice Setting]
is set to "Permit", the setting to turn sleep on and off displays and
becomes selectable.
• The sleep mode will begin in 48 hours even if it sets it to "OFF."
• The upper limit can be set up to 240 min. only when the switch number
"157" is specified to "02" at HEX assignment by setting [Service Mode] -
> [System 2] -> [Software Switch Setting].
It will not be displayed when image controller is mounted.
-
-
• It will not be displayed when image controller is mounted.
• In ErP auto power OFF mode, this machine cannot receive data, and
also it cannot print an original.
-
When "Yes" is selected, using the 10-key pad, input the Power Save Start
Time and Power Save End Time.
When the setting is enabled, enter the password (eight digits).
-
• By making settings in [Service Mode] -> [Billing Setting], CE can also
activate functions provided by i-Option.
H-8
H UTILITY MODE > 6. Administrator
Advertisement
