Table of Contents
Advertisement
2. Connect channel 0 of the controller to the Host system's SCS-I
port using a suitable SCSI cable.
Channel 0 is the default Host interface using ID
number '0'. Any of the channels can also be set as
the Host interface. More than one channel can be set
as the Host interface when operating with redundant
Host or multiple Host systems.
3. Make sure the host side of the SCSI cable is properly terminated.
4. Assign a unique SCSI ID for every hard disks that are to be
connected on the same SCSI cable; between ID numbers '0' and
'6' and '8' and '15'. The default ID of the controller's channel 0 is
'7'.
5. Connect the other end of the drive SCSI cable to one of the
remaining channel on the controller.
6. Connect the connectors located at the middle of the drive SCSI
cable to the hard disk(s).
7. Terminate the SCSI cable by installing an external terminator on
the last connector. Terminators on all the hard drives must be
removed so that removing a hard drive will not affect cable
termination.
54
User's Guide
Advertisement
Table of Contents
