Table of Contents
Advertisement
To prevent this from happening, the controller provides an easy way of
identifying for the failed drive. That is, the read/write LED of the failed
hard drive will light. This LED will prevent you from removing the
wrong drive, and is also helpful when locating for a drive.
Flash Selected SCSI Drive
The Read/Write LED of the drive you selected
will light steadily for about one minute.
This
applies
versions 2.11 and above.
Flash All SCSI Drives
The Read/Write LED of all connected drives
will light for about one minute. If the LED of the
defective drive did not light on the "Flash
Selected SCSI Drive" function, use "Flash All
SCSI Drives". The "Flash All SCSI Drives"
function will light LEDs of all the drives except
the defective one.
This
applies
versions 2.11 and above.
Chapter 3 Functional Descriptions
R/W LED
R/W LED
LED Steadily ON
to
firmware
R/W LED
R/W LED
LED Steadily ON
LED Steadily ON
LED Steadily ON
LED Steadily ON
LED Steadily ON
to
firmware
17
Advertisement
Table of Contents
