Table of Contents
Advertisement
Choose a Drive channel, then press [Enter]. Choose "Primary
Controller SCSI ID". A list of SCSI IDs will be displayed on the screen.
Only one SCSI ID can be assigned to the drive channel of a controller.
Now choose a SCSI ID for the drive channel of the Primary Controller.
The dialog box "Change Primary Controller SCSI ID?" will appear.
Select Yes, then press [Enter].
Every time you change a channel's SCSI ID, you
must reset the controller for the changes to take
effect.
The default SCSI ID of the Host channel is 0, the
Drive channel is 7.
If only one controller exist, you must set the
Secondary Controller's SCSI ID to "NA". If a
secondary controller exist, you need to set a
SCSI ID.
Multiple SCSI ID can be applied to the Host
channel while the Drive channel, one SCSI ID or
no SCSI ID.
Multiple SCSI ID is supported in firmware version
2.11 or later. Firmware versions earlier than 2.11
only supports one SCSI ID.
At least a controller's SCSI ID has to be present
on the SCSI bus.
Chapter 8 RS-232C Terminal Interface
159
Advertisement
Table of Contents
