Table of Contents
Advertisement
To change the SCSI ID of the host, delete the current ID
before replacing a new one.
DELETING A SCSI CHANNEL'S ID
Press t or s to choose "Add Channel
SCSI ID ", then press ENT.
Press t or s to choose "Primary
Controller", then press ENT for two
seconds.
Press t or s to choose the SCSI ID you
wish to add, then press ENT for two
seconds.
Every time you change a channel's SCSI ID, you
must reset the controller for the changes to take
effect.
The default SCSI ID of the Host channel is 0, the
Drive channel is 7.
If only one controller exist, you must set the
Secondary Controller's SCSI ID to "NA". If a
secondary controller exist, you need to set a
SCSI ID.
Multiple SCSI ID can be applied to the Host
channel while the Drive channel, one SCSI ID or
no SCSI ID.
Multiple SCSI ID is supported in firmware version
2.11 or later. Firmware versions earlier than 2.11
only supports one SCSI ID.
At least a controller's SCSI ID has to be present
on the SCSI bus.
102
Add Channel
SCSI ID
..
Primary
Controller
?
Add CHL=0 ID=2
Primary Ctlr
?
User's Guide
Advertisement
Table of Contents
