Table of Contents
Advertisement
Basic Operational setup
An example of the operational setup is shown below:
RAID
Controller
Host CH0
Drive CH1
Drive CH2
(Terminator Enabled)
SCSI cable
SCSI cable
The SCSI cable must be shorter than 3 meters.
Channel 0 is connected to the Host system.
Drives are connected to drive channels 1 and/or 2.
SCSI nodes on the same channel have their own unique ID
number.
Both the Host and drive SCSI cables are properly terminated.
The terminator of all the hard drives must be disabled.
The power supply is attached.
All operation parameters are properly set.
To connect the components:
1. Make sure power is off or the power connector is disconnected.
Chapter 4 Hardware Installation
SCSI cable
Host Computer
(Terminator Enabled)
Terminator
.....
Terminator
.....
53
Advertisement
Table of Contents
