Table of Contents
Advertisement
Setting the Transfer Width
The controller supports 8-bit SCSI and 16-bit SCSI. Enable "Wide
Transfer" to use the 16-bit SCSI function. Disabling "Wide Transfer"
will limit the controller to 8-bit SCSI.
Press ENT for two seconds to enter the
Main Menu. Press t or s to select "View
and Edit SCSI Channels", then press
ENT.
SCSI
channel
information
displayed on the LCD. Press t or s to
browse through the information of every
SCSI channel. Press ENT on the channel
you wish the transfer width changed.
Press t or s to select "Set Transfer
Width", then press ENT.
The current mode will be displayed on
the LCD. Press ENT to continue.
Press ENT again for two seconds.
Every time you change the SCSI Transfer Width, you
must reset the controller for the changes to take
effect.
Chapter 7 General Front Panel Operation
View and Edit
SCSI Channels
will
be
CH0=Host
SID=NA SXF=20.0M
Set Transfer
Width
Wide Transfer
Enabled
Disable
Wide Transfer
×
PID=0
..
..
?
107
Advertisement
Table of Contents
